google-site-verification: googleb86aec972df3e1f0.html
Manual Prime Jet Pumps
Complete Dewatering’s High-Pressure Jet Pumps are used for water jetting wellpoint punches, casings, and self-jetting wellpoints into hard ground conditions.  They are also suited for temporary pumping under discharge pressure conditions or high discharge lifts.  CDPW can design and build high pressure pumps from 80 to 300 PSI, either diesel or electric powered.  CALL COMPLETE WITH YOUR SPECIFIC APPLICATION.
Economy model (2-1/2 JPE) for hand jetting and small punches. 
Standard model (2-1/2 JP) for hand jetting and small punches or casings. 
High pressure model (3 JP) for large punches or casings or hose runs greater than 400’.
Catalog Sheet
Download Cut Sheet 2.5" Jet Pump Economy
Download Cut Sheet 2.5" Jet Pump 
Download Cut Sheet 3" Jet Pump 
*Specify model JPE = Jet Pump Economy or JP = Jet Pump   
  • Welded steel integral fuel tank sized for 24hr run time; clean out ports at all four corners
  • Cast iron pump construction
  • Balanced impeller engine SAE mount or long coupled pump
  • Hardened steel pump shaft
  • High pressure brass gate valve on discharge
  • Electric start / alternator
  • Extra-large hand primer
  • Standard all models: Lockable fuel cap, Battery hold-down, Single point lifting bail, and Volute drain
  • --Murphy engine control panel
  • --Diesel engine (Tier 3 rebuilt or Tier 4 new) or Electric motor options available

  • Engines: Deutz, John Deere, Kohler, Isuzu or Yanmar (additional engines available upon request)
  • “Whisper Pack” full or partial enclosures
  • Trailer mounted: Highway wheels / tires, Torsion bar axle, DOT light kit, Highway fenders, Tow hitch, and Brake kit available
  • Frame mounted hose carry racks and baskets
  • Camlock suction and discharge fittings (please consult CDPW for additional fittings)
  • Jetting for bridge pilings and wellpointing
  • Irrigation for golf courses and agriculture
  • Washing of crushed rock and industrial equipment
  • ​Water blasting applications